User Manual

Library Security Pedestal 3
10/68 Revision 2.1 December 2009
1 For Your Safety
1.1 General Use
The L-SP3 is designed to be rugged and reliable and to provide years of trouble-free
service. Please observe the following general tips:
 Take care not to scratch the device. Keep the device clean. When working with the device,
use only TAGSYS-approved accessories.
 This device is not waterproof and should not be exposed to rain or moisture. Under extreme
conditions, water may enter the circuitry.
 Protect the device from extreme temperatures. For example, do not place the device in a
windowed area where the sun may cause extreme temperatures, and keep it away from
heaters and other heat sources.
 Do not store or use the device in any location that is extremely dusty, damp, or wet.
 Use a soft, damp cloth to clean the device. If the surface of the device becomes soiled,
clean it with a soft cloth moistened with a diluted window-cleaning solution.
1.2 Care and Maintenance
This device is a high end design and should be handled with care to maintain its
appearance in public locations. The suggestions below will further increase the lifetime and day
to day appearance of this device.
 Keep the device dry. Precipitation, humidity and liquids contain minerals that will corrode
electronic circuits and tarnish transparent plastic parts.
 Do not store the device in dusty, dirty areas. Its moving parts can be damaged.
 Regularly dust the large transparent part using a soft cloth and antistatic liquid.
 Do not store in hot areas. High temperatures can shorten the life of electronic devices,
damage batteries and warp or melt certain plastics.
 Do not store in cold areas. When the device warms up (to its normal temperature), moisture
can form inside the device, which may damage electronic circuit boards.
 Do not attempt to open the device during operation, outside installation and maintenance
periods. Non-professional handling of the device may damage it.
 Handle the device with care. Shocks may break internal circuit boards.
 Do not paint the device. Paint may clog the device’s moving parts and prevent proper
operation. Paint with metallic contents may limit device performances.
 If the device or any accessory are not working properly, take it to your nearest qualified
TAGSYS representative.
Do not clean the device, particularly the transparent plastic parts, with harsh
chemicals, cleaning solvents or strong detergents. Gently wipe the device with a soft
cloth slightly dampened in a mild soap-and-water solution. Eliminate any residual
moisture with another clean and wet soft cloth.
Also regularly apply specific antistatic products for Acrylic Surfaces.