User Manual

December 2009 Revision 2.1 45/68
5.4.5 Basic Pedestal Configuration
Figure 22: Basic Pedestal Configuration Tab
This tab is used either:
• To select the chip to be detected as well as detection options.
• To configure inter-pedestal RF synchronization.
• To configure / test alarm duration.
• To configure the 2 GPIO available to user with predefined functions.
Selecting the chips to be detected as well as detection options
In the “Chips” section, first tick the family of chips to be detected:
• TAGSYS proprietary C220 asynchronous or C320 synchronous legacy chips
• ISO15693 synchronous chips: NXP, TI or Generic (no support of multiple memory Blocks
Reading in Inventory mode). Select the ISO15693 chip type from the drop-list.
• Or both C220/C320 and then ISO15693 EAS detection.