User Manual

52/68 Revision 2.1 December 2009
5.4.6 Advanced Pedestal Configuration
Figure 29: Advanced Pedestal Configuration Tab
This tab is used either:
• To configure advanced inter-pedestal RF synchronization parameters.
• To configure advanced alarm detection parameters.
• To configure advanced alarm signaling parameters.
• To configure antenna sequence, RF output power and region of operation.
• To configure the Asynchronous Event Notification over the network
Configuring advanced inter-pedestal RF synchronization parameters
In “Synchro” section, select whether synchronization should be compatible with L-SP2 pedestals.
Please note that some features may not be available when this mode is selected.
You can also select whether to use hardwire synchronization (see section 5.2.3) or wireless
synchronization (see section 5.2.2).