User Manual

Medio L40 - User's Guide
8/56 Revision 2.3 July 2013
1 For Your Safety
1.1 General Use
The Medio L40 reader is designed to be reliable and to provide continuous, trouble-free service.
Please observe the following general tips:
 Take care not to scratch the device. Keep the device clean. When working with the device,
use only TAGSYS-approved accessories.
 This device is not waterproof and should not be exposed to rain or moisture. Under extreme
conditions, water may enter the circuitry.
 Protect the device from extreme temperatures. For example, do not place the device in a
windowed area where the sun may cause extreme temperatures, and keep it away from
heaters and other heat sources.
 Do not store or use the device in any location that is extremely dusty, damp, or wet.
 Use a soft, damp cloth to clean the device. If the surface of the device becomes soiled,
clean it with a soft cloth moistened with a diluted window-cleaning solution.
 MEDIO L40 shall be supplied by LPS (limited power source) power supply in accordance to
clause 2.5 of UL/IEC 60950-1 Edition 2 with following ratings 24Vdc, 1.6A min suitable for a
minimum 40°C (104°F). Only use the recommended Powe r Supply Unit A2-50S18R-V
manufactured by VP ELECTRONIQUE or VEH40US24 manufactured by XP Power.
1.2 Care and Maintenance
This device should be handled with care. The suggestions below will increase the lifetime of this
device.
• Keep the device and all parts and accessories out of the reach of small children.
• Keep the device dry. Precipitation, humidity and liquids contain minerals that will corrode
electronic circuits.
• Do not use or store the device in dusty, dirty areas. Its moving parts can be damaged.
• Do not store in hot areas. High temperatures can shorten the life of electronic devices,
damage batteries and warp or melt certain plastics.
• Do not store in cold areas. When the device warms up (to its normal temperature), moisture
can form inside the device, which may damage electronic circuit boards.
• Do not attempt to open the device. Non-professional handling of the device may damage it
and will void the TAGSYS warranty.
• Handle the device with care. Shock and vibration may break internal circuit boards.
• Do not clean the device with harsh chemicals, cleaning solvents or strong detergents.
Gently wipe the device with a soft cloth slightly dampened in a mild soap-and-water
solution.
• Do not paint the device. Paint may clog the device’s moving parts and prevent proper
operation. Paint with metallic contents may limit device performances.
• If the device or any accessory are not working properly, take it to your nearest qualified
TAGSYS representative.