User Manual

Medio P101-WIFI
18/42 Revision 1.0 February 2006
When USB communication link is active (plugged and powered) the WIFI module is turned
off.
4.2 Communicate with WIFI Interface
Preliminary checking:
- USB cable must be unplugged to ensure that the WiFi Module is turned on
- WiFi antenna must be correctly connected to the rear panel
The embedded WiFi module is the DigiConnect Wi-ME. Any information on this module is available
on the CDROM in the directory “\DigiConnect IntegrationKit\Documentation” or on the DigiConnect
WEB pages at “www.digi.com”.
Please read the DigiConnect User’s Guide to have an overview of the module characteristics.
The following explanations will give you the first steps to run the reader. Advanced functionalities
can be found in the DigiConnect User’s Guide.
Before you power the reader up you must plug the WIFI antenna provided with the Medio
P101-WIFI product
This FCC Part 15 radio device operates on a non-interference basis with other devices
operating at this frequency when using the supplied antenna. Any changes or modification to
this product not expressly approved by TAGSYS could void the user’s authority to operate
the device.
You cannot connect any RF antennas to this connector (plugs don’t match)