User Manual

Installing the Reader
February 2006 Revision 1.0 21/42
• RF Exposure Statement
The Medio P101-WIFI module complies with the RF exposure limits for humans as called out
in RSS-102. It exempt from RF evaluation based on its operating frequency of 2.4 GHz, and
effective radiated power less than the 3 watt requirement for a mobile device (>20 cm
separation) operating at 2.4 GHz.
• Safety Statements
- Do not touch or move the WIFI antenna while the unit is transmitting or receiving
- Do not hold the reader such that the antenna is very close to or touching the head
(especially face or eyes), while transmitting.
- Do not operate a portable transmitter near unshielded blasting caps or in an explosive
environment unless it is a type especially qualified for such use.
4.2.2 Default Reader Network Settings
You will not be able to configure any network setting before the reader is not engaged with your
access point.
It depends to you to engage the reader with your access point correctly first. You should use a
specific network to initialize the reader network accordingly your final network.
The mandatory information you need are the following:
- the reader is compliant with IEEE 802.11b. Please check your access point is able to
support this standard (access point configuration “b or g” or “b only”)
- SSID of the reader is TAGSYSRFID and the access point must be set accordingly
- No encryption is used to communicate with the reader
The SSID and the Encryption status can be changed afterward.
Additionally, the default settings for the reader network configuration are :
- DHCP : Off
- Static IP Address : 192.168.0.2
- Subnet Mask : 255.255.255.0
- Default Gateway : 0.0.0.0
- SSID : TAGSYSRFID
- Available to any wireless network
- Country : United States
- Channel : Auto-scan
- Network Authentication : Open System
- Data Encryption : Open System
You can now configure your access point to engage the reader or follow the ADDP procedure to
change the basic network IP settings.