Installation Guide

ManualsBrandsTahanbath ManualsBathDouble Handle Wall Mount Bathroom Faucet in Matte Black

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

For the following installation instructions for

your new Wall-Mount Faucet, it is assumed

that any old ﬁxtures have been removed

and the water supply lines have been

relocated to the proper installation location.

*not included

Ensure that you have gathered all of the

required materials that are needed for

the installation.

Plumber’s Tape*

Shut oﬀ the main water supply where the

new faucet is being installed.

PLANNING

Drill*

Thread Sealant*

Tape Measure* Level*

Hex Wrench

14mm

Socket Wrench*

Use the faucet’s PDF speciﬁcation sheet as

a reference when planning your installation.

The speciﬁcation sheet can be found and

downloaded from the product page on our

website.

WAL

L-MOUNT FAUCET

We recommend consulti

ng a professional if

you are unfamiliar with in

stalling bathroom

ﬁxtures and plumbing.

We accepts no

liability for an

y damage to the

ﬂoor, walls, plumbing, or p

ersonal injury

during installation.

Wall-Mount Faucet Installation Instructions

Summary of content (4 pages)

PAGE 1
WALL-MOUNT FAUCET BEFORE YOU BEGIN GETTING STARTED We recommend consulting a professional if you are unfamiliar with installing bathroom ﬁxtures and plumbing. We accepts no liability for any damage to the ﬂoor, walls, plumbing, or personal injury during installation. Ensure that you have gathered all of the required materials that are needed for the installation.
PAGE 2
WALL-MOUNT FAUCET INSTALLATION 1. Prepare for installation by installing wood blocking between the two studs where the faucet will mount. The valve should be installed 2" behind the ﬁnished wall. Important: Take into consideration the thickness of your ﬁnished wall materials, such as a tile backsplash. If your valve is installed too far behind your ﬁnished wall, you may be left with insuﬃcient clearance to attach the spout and handles. 2. Mount the rough-in valve into its prepared location.
PAGE 3
WALL-MOUNT FAUCET 4. Once your ﬁnished wall has been completed, remove the protective plastic sleeves from the valve. Remove the plug from the spout outlet using a 14mm socket wrench. 6. Attach the spout to the valve by twisting it into the middle valve outlet. Apply plumber’s tape or a small amount of thread sealant to the threads before attaching. 5. Slide the decorative escutcheons onto the spout and each handle.
PAGE 4
WALL-MOUNT FAUCET 7. Attach the hot and cold handles by sliding them onto the left and right stems. Secure each handle by tightening the set screw on the bottom of the handle, using the provided hex wrench. 8. When your installation is complete, turn on the main water supply. Use the provided tool to remove the aerator from the spout. Turn the water on to allow any dust or loose sediment to clear the system.