Installation Guide

Applicable faucets (including but not limited)

TOOLS YOU WILL NEED

Adjustable wrench

phillips

screwdrive

Hex Wrench

Two Male

Supply

pipe tape

Silicone

sealant/Putty

INSTALLATION

prior to installation: Shut off water supply .Remove old faucet .

Clean sink/countertop surface in preparation for new faucet

Apply some plumbers putty

or other suitable sealant to the

bottom edge of undercover.

Allign and press into place

Insert the faucet through sink

Screw the nut onto shrank,leaving

approximately 0.12"(3mm)

between the ring and the sink.

Connect and tighten the supply hoses.

Two Handle Centerset Lavatory Faucet

Right of product modification such as dimension without notice is reserved.

1 2 3 4

Tighten fitting nuts with adjustable

wrench. Do not over tighten!

Romove excessive putty,adjust

slightly the position of faucet

PAGE 1
Two Handle Centerset Lavatory Faucet Applicable faucets (including but not limited) INSTALLATION prior to installation: Shut off water supply .Remove old faucet . Clean sink/countertop surface in preparation for new faucet 1 Apply some plumbers putty or other suitable sealant to the bottom edge of undercover. 2 3 Allign and press into place 5 4 Screw the nut onto shrank,leaving Insert the faucet through sink approximately 0.12"(3mm) between the ring and the sink.
PAGE 2
Two Handle Centerset Lavatory Faucet 8 9 Care and Cleaning For best results,keep the following in mind when caring for your VAPSINT product: .Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not use abrasive cleaners that may scratch or dull the surface. .Carefully read the cleaner product label to ensure the cleaner is safe for use on the material. .Do not allow cleaners to sit or soak on the surface. .