User Manual

How to do a control solution test?

Step 1- Insert a test strip and check if the code number shown on LCD display

is the same as the code on the strip bottle.

Step 2- Press the M Button. The symbol "CtL" will appear on the display.

When you do this, control solution readings will not be stored in the memory.

Step 3- Get a drop of control solution:

1. Shake the control solution vial well.

2. Remove the cap. Squeeze the vial and

discard the first drop with a clean tissue to

ensure an accurate result.

3. Squeeze the vial again to get a hanging

drop and place the drop on your fingertip.

(Fig.13)

Step 4- Apply the drop to the absorbent hole of the test strip

until the drop is drawn into the test strip, and the confirmation

window is filled. (Fig. 14)

Step 5- The monitor will begin countdown. After 10 seconds, the control

solution test result will appear. The result should fall within the range printed

on the test strip vial.

(Fig. 13)

(Fig. 14)