Medicine Cabinet 16"W x 20"H 20"W x 26"H COPY THE MODEL NUMBER FOR YOU REGARDS HERE # READ THE INSTRUCTIONS CAREFULLY, familiarize yourself with all the parts as shown in the exploded view. The exploded view will also provide a helpful reference when relating to the location of the various parts and how they are mounted.
PARTS LIST.
Determining Measurement and Direction: Model No.| Height Width Depth |Tolerance 2026 25" 19 1/2" 4" +1/8" 1620 19" 151/2" 4" +1/8" 1" clearance Fig 2 Fig 9 If needed ,please turn over the upside to downside ,you may get the opposite hand installations .
Recessed or semi-recessed 1. Peel off the side kits from the cabinet as figure shown. Peel off the side kits Semi-recessed 2. Make sure hinges are on correct side of opening for left hand or right hand operation. Place cabinet box into rough opening. On fully recessed applications, make sure cabinet flange covers rough opening evenly all around (Fig 3). On semi-recess applications, mirror edges should meet wall surface. (Fig 4). Shim as needed. 3.
How to Surface Mount Cabinet If installing in combination with a middle mirror/shelf kit, please see “Center Mirror/Shelf Kit Installation” Directions that came with your center mirror prior to preforming the steps below 1. Establish precise height and draw a level horizontal line (Fig 6). IMPORTANT: Detect medicine cabinet at precise height. Make sure there is at least 17 of clearance above any obstructions. 0 2.
4. Insert surface mount z-clips @as shown (Fig 9 & 10). Fig 10 Fig@ 5. Place cabinet into wall bracket (Fig 11). Mark hole locations of z-clips (Fig 12). When determining location, it is recommended that at least one z-clip be located at a stud . Detach cabinet and drill 8mm hole if needed for anchor, and place in anchor in hole. 6 .Remount cabinet and connect with 1/2" &) screws (Fig 13).
Door Installation 1 .Remove protective packaging from door ,be careful not to bump edges of mirror. Line hinges up against hinge mounting plates. Snap into position . (Fig 14). Mounting Plate Snap into position Button Pull to release Fig 14 2 .Door should "snap” locked when about 1" from being fully closed. Door should be placed even in relation to cabinet. Insert bumper @2 (Fig 15).
Additional Item Installation 1 .Insert clear shelf clip Q) into appropriate hole location using 2 clips per shelf {(Fig 16). Place glass shelf@on top of clear shelf clips making sure shelf is against back of cabinet. Press lightly to adhere the shelf ¢lip sticker (Fig 17). ® P 3 Fill remaining holes with hole plugs(3) (Fig 18).