User_Manual_Taisync_Pro_V1.00(ETH-ETH)-EN-20200529

17
1. Connect antennas to RF ports of the ground unit.
2. Adjust the remote controller to the training mode, if PPM mode is used, the remote
controller interface at the ground end is connected to the training port of the remote
control. If S.BUS mode is used, the cable connection between the S.BUS receiver
and the ground end need to be established, and the connection between the receiver
and the remote control need to be established.
3. Connect the USB port of ground control station to the serial port of the ground unit
with TTL-USB cable if you want to use Taisync’s telemetry link.
4. If video view on a PC or a Laptop is desired, connect a PC or a Laptop to the
ethernet port of the ground unit.
5. Connect a 12V DC power to the power port of the ground unit and turn on the
power.
6. If latest firmware is desired, connect the ground unit to a PC or a Laptop using USB
cable and run Taisync PC program to upgrade the firmware of the ground unit to the
latest one.