User_Manual_Taisync_Pro_V1.00(ETH-ETH)-EN-20200529

When using S. BUS mode, the air unit needs to connect the DSM/S. BUS RC port of Pixhawk4.

5.2.1. FRSKY remote controller

PPM mode

Model setup - Trainer - mode, if mode is configured to Slave/Jack, then the remote controller

is in PPM mode.

Model setup - Internal RF, it is needed to be configured to off, S. bus mode will be closed.

S.BUS mode

Model setup - Internal RF: LR12, D8, D16, OFF. Configuration of different parameters is

according to the receiver. If configured as off, S. bus mode will be closed.

5.2.2. Futaba remote controller

S.BUS mode

Linkage menu - system: FASSTest-14CH, FASSTest 12CH, FASST MULTI, FASST 7CH,

S-FHSS. Configuration of different parameters is according to the receiver.