User_Manual_Taisync_Pro_V1.00(ETH-ETH)-EN-20200529

http://www.l-com.com/content/Article.aspx?Type=P&ID=10699

http://www.l-com.com/audio-video-micro-hdmi-to-hdmi-cables

http://www.l-com.com/audio-video-hdmi-female-to-micro-hdmi-male-adapter

⚫ Interference by USB divider/hub

Some USB dividers or hubs may cause EMI to wireless device. When using USB dividers or

hubs, please check if EMI is existing.

⚫ RF cable connector/Antenna connector check

Before flight, check if the antennas are connected to the modules. Running module without

antenna connected results in very short range and potentially can damage the module. It is

recommended to check the connection of all RF connectors. Loose connection can degrade

the range significantly.

⚫ Antenna placement

Place the two air antennas so that no matter what position the drone is, at lease one antenna is

not blocked by the payload from the ground station.

If the drone will fly in full throttle, it will lean forward. Install the air antenna so that it is close

to be vertical to the ground when the drone moves forward in full throttle.

⚫ Battery level of ground station

The reception performance will degrade if the battery of ground station runs low, even though

it might still power the wireless ground unit up.

6.2.RC link & remote controller

The RC link of Taisync module supports the PPM and S.BUS protocols. If the PPM protocol

is used, you need to configure the remote controller to PPM mode and turn off the wireless

transmission of the remote controller. If the S.BUS protocol is used, the wireless working