User_Manual_Taisync_Pro_V1.00(ETH-ETH)-EN-20200529

41
7. FAQ
Q1: How to install management software and driver, and how to use management software?
Please read Chapter 4 of this document.
Q2: How does the Taisync module supply power?
Air unit: DC, power supply range: 8-15V, recommended to use 12V, Taiysnc provides power
supply cables.
Ground unit: DC, power supply range: 8-15V, recommended to use 12V, Taiysnc provides
power supply cables.
Q3: Can the Taisync module be powered on before antennas installation?
The antennas must be installed before power on.
Q4: How many antennas do Taisync's air unit need to be installed?
Two antennas need to be installed.
Q5: How many antennas do Taisync's ground unit need to be installed?
Two antennas need to be installed.
Q6: Can different types of remote controllers be used to control drone?
Yes, just output standard PPM signals through the coach port, or use S. BUS receiver.
Q7: Can two air units be installed on a drone?
No, a drone can only integrate one air unit.
Q8: Can two ground units be installed at the receiving end?
The ptp system can only install one ground unit; the ptmp system supports more than one
ground units.
Q9: There are some devices nearby, such as WIFI, Bluetooth and so on. Can they be opened
when flying?
Be sure to turn off WIFI, Bluetooth and other functions of other devices, because these
devices are working in 2.4 GHz band, It can cause interference.
Q10: After integrating the Taisync air unit, GPS is not good at searching for stars. What
should we do?
Please check whether the antennas of air unit is far away from GPS to avoid blocking
interference to GPS. The frequency band of 1.4G module is close to working frequency of GPS, so
it is necessary to ensure a certain degree of antenna isolation.
Q11: What do the four LED lights of the ground unit stand for?