User_Manual_Taisync_Pro_V1.00(ETH-ETH)-EN-20200529

6
① Fan Ventilation Outlet
Don’t block this fan ventilation outlet to ensure effective cooling.
2.3.Ground Unit Interfaces
① Power Input Port
Connect 12V power source to this port. The power source can be from a battery, or can be
from a power adaptor when the ground unit is upgraded on the ground. The power supply
recommended 3s battery.
② RJ45 Port
Connect this ethernet output port to the ethernet input port of a camera using the supplied
RJ45 cable.
③ Serial Port (UART)
Connect this port to the telemetry port of a remote controller, or the serial port of a ground
control station to setup a telemetry link between the drone and the remote controller or the
ground control station. UART singal: LVCMOS-3.3V.
④ Remote Control Port (RC)
Connect this port to the training PPM/S.bus port of a remote controller. Remote controller
can use ViUlinxTM uplink to communicate with the drone. Pin V + can provide 5V
power supply.
⑤ Micro USB Port
Connect this port to the USB port of a PC or Laptop, and use the Taisync PC program to
upgrade firmware on the air unit.
①
①
②
③
④
⑤