_User_Manual_Taisync_Pro_V2.00(HDMI-ETH-ETH)-EN-20210513

(3) Both antennas need to be installed.

(4) Ensure the antenna connector is vertical to the module when it is pushed into the RF

port.

(5) When uninstall the antenna, hold the connector and pull it out of the RF port. Do not

pull the cable.

3.1.2. Power supply

Pin-out: - - + +. Insert the four-pin connector of supplied power cable to the power port

of the air unit and connect the supplied power cable to a battery output, or the power

supply port of a drone. Recommended voltage is 12V.

Note:

(1) To avoid equipment damage, install antennas before powering on the units.

(2) Recommended rated voltage/current is DC12V/1.2A (or 3S lithium battery).