_User_Manual_Taisync_Pro_V2.00(HDMI-ETH-ETH)-EN-20210513

Insert the ground unit antennas into the RF ports with RF cables. RF cables clicks in when

properly installed.

Note:

(1) To avoid equipment damage, install antennas before powering on the units.

(2) Both antennas need to be installed.

(3) Ensure the antenna connector is vertical to the module when it is pushed into the RF

port.

(4) When uninstall the antenna, hold the connector and pull it out of the RF port. Do not

pull the cable.

3.2.2. Power supply

Pin-out: - - + +. Insert the four-pin connector of supplied power cable to the power port of the

air unit and connect the orange power connect of supplied power cable to a battery output, or

the power supply port of DC. Recommended voltage is 12V.

Note:

(1) Recommended rated voltage/current is DC12V/1.2A (or 3S lithium battery).

(2) To avoid equipment damage, install antennas before powering on the units.