_User_Manual_Taisync_Pro_V2.00(HDMI-ETH-ETH)-EN-20210513

45
Q6: Can two air units be installed on a drone?
No, a drone can only integrate one air unit.
Q7: Can two ground units be installed at the receiving end?
The ptp system can only install one ground unit; the ptmp system supports more than one
ground units.
Q8: There are some devices nearby, such as WIFI, Bluetooth and so on. Can they be opened
when flying?
If 2.4GHz Taisync modules used, make sure to turn off WIFI, Bluetooth and other functions of
other devices like mobile phone, car key, because these devices are working in 2.4 GHz band, it
can cause interference.
Q9: There are USB3.0 hub and/or HDMI cable used, will they affect the SprintLink wireless
system?
If 2.4GHz Taisync modules used, make sure to keep USB3.0 hub and/or HDMI cable away
from antenna.
Q10: After integrating the Taisync air unit, GPS is not good at searching for stars. What
should we do?
Please check whether the antennas of air unit is far away from GPS to avoid blocking
interference to GPS. The frequency band of 1.4G module is close to working frequency of GPS, so
it is necessary to ensure a certain degree of antenna isolation.
Q11: What do the four LED lights of the ground unit stand for?
LED 1 (downlink Indicator): The LED is on indicates that the air-to-ground link is connected;
the LED is not on indicates that the air-to-ground link is disconnected. LED1 locates at the same
side of bind button and next to bind button.
LED 2(uplink Indicator): The LED is on indicates that the ground-to-air link is connected; LED
is not on indicates that the ground-to-air link is disconnected. LED2 locates at the same side of
bind button and next to LED1.
LED 3 (Network Data Link Indicator): The LED is flickering indicates that the data link is
connected; not flickering indicates that the data link is disconnected. Seen from fan up-ward
view, LED3 locates at the left side of LED4.
LED 4 (Network Physical Link Indicator): The LED is on indicates that the data link is
connected; otherwise it indicates that the data link is disconnected. Seen from fan up-ward view,
LED4 locates at the right side of LED3.
Q12: What do the two LED lights of the HDMI ground unit stand for?
LED 1 (downlink Indicator): The LED is on indicates that the air-to-ground link is connected;
the LED is not on indicates that the air-to-ground link is disconnected.
LED 2(uplink Indicator): The LED is on indicates that the ground-to-air link is connected; the
LED is not on indicates that the ground-to-air link is disconnected.
Q13: What if the uplink LED indicator of ground unit is not on?
Please follow the following steps: