_User_Manual_Taisync_Pro_V2.00(HDMI-ETH-ETH)-EN-20210513

2
（feeder line for ground unit, applied for N connector antenna）
Air Unit Cables
Power cable x1
This is used to connect the output
of a battery to the power input of
the air unit.
HDMI cable (Micro to Micro) ×1
This is used to connect the HDMI
output of camera to the HDMI
input of the air unit.
RJ45 cable ×1
This is used to connect the ETH
output of camera to the ETH
input of the air unit.
RC cable x1
This is used to connect the
PPM/S.bus port of flight
controller to the RC port of the air
unit.
Serial cable (UART) x1
This is used to connect the
telemetry port of flight controller
to the serial port of the air unit.
Ground Unit Cables
Power cable x1
This is used to connect the output
of a battery to the power input of
the air unit.
RJ45 cable ×1
This is used to connect the
Ethernet output of ground unit to
PC.
PPM RC cable x1
This is used to connect the
training port of a remote