_User_Manual_Taisync_Pro_V2.00(HDMI-ETH-ETH)-EN-20210513

47
1) Please check whether the link state is normal, please refer to Question 13 and Question 14
if it is abnormal.
2) Please check whether the RC port both the air and the ground units is correct.
3) Please check whether the RC connecting between flight controller and air unit is correct and
that between ground unit and remote controller is correct.
4) If using PPM mode, check the mode configuration of the remote controller; if using S. BUS
mode, check the configuration of the receiver and remote controller.
5) Please check whether the RC connection of the air and ground unit is correct. We provides
standard cables. If you make it by yourself, please check the pin.
6) Please check whether the RC mode is configured correctly with Taiysnc PC management
software.
7) If above steps cannot solve the problem, please contact Taisync technical support staff.
Q18: After connecting Taisync module, RC can not be connected properly?
Please follow the following steps:
1) Please check whether the link state is normal, please refer to Question 12 and Question
13 if it is abnormal.
2) Please check whether the RC port both the air and the ground units is correct.
3) Please check whether the RC connecting between flight controller and air unit is correct
and that between ground unit and remote contriller is correct.
4) If using PPM mode, check the mode configuration of the remote controller; if using S.
BUS mode, check the configuration of the receiver and remote controller;
5) Please check whether the RC connection of the air and ground unit is correct. We
provides standard cables. If you make it by yourself, please check the pin.
6) Please check whether the RC mode is configured correctly with Taiysnc PC management
software.
7) If the above steps can not solve the problem, please contact Taisync technical support
staff.
Q19: After connecting Taisync module, video can not be output properly?
Please follow the following steps:
1) Please check whether the link state is normal, please refer to Question 13 and Question
14 if it is abnormal.
2) Please confirm whether the Ethernet physical link and the Ethernet data link indicators are
normal, if not, please refer to Question 15 and Question 16(only applicable for ETH ground unit).
3) Please confirm the IP address, login username and password of the used IP camera.