User_Manual_Taisync_V1.5.0-1(HDMI-HDMI)-EN

Insert the power connector of the power adaptor into the charging port of the ground unit and

insert into the aerial plug into an electrical outlet to fully charge the battery of ground unit.

Recommended voltage is 12V.

Note:

(1) Recommended rated voltage/current is DC12V/1.2A (or 3S lithium battery).

(2) To avoid equipment damage, install antennas before powering on the units.

3.2.3. Telemetry connection

Insert the six-pin connector of supplied serial cable to the serial port of the ground unit and

connect the other end of supplied serial cable to the telemetry port of the ground control

station.

Note:

(1) Ensure the baud rate of ground station and the baud rate of Taisync module are

configured correctly.

(2) Ensure the serial cable sequence matches the interface definition of Taisync module.