User_Manual_Taisync_V1.5.0-1(HDMI-HDMI)-EN

32
5.2.2. Futaba remote controller
S.BUS mode
Linkage menu - system: FASSTest-14CH, FASSTest 12CH, FASST MULTI, FASST 7CH, S-
FHSS. Configuration of different parameters is according to the receiver.
PPM mode
Taisync standard PPM cable is used to connect with Futaba trainer cable (one end is connected
to the trainer port of futaba, the other end is 3.5mm connector). PPM mode can be used directly
without additional configuration.
5.3.Telemetry connection
The telemetry Port of air unit connects “TELEM1” Port of flight control (Pixhawk4).