Installation and Operation Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Connecting to the Base Station
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Single or channel group base stations
- 4.4.6 Marshaling or transmit delay
- 4.4.7 Configuring Receive-Only Base Stations
- 4.4.8 Setting Up Custom Alarms
- 4.4.9 Uploading Firmware from the Base Station
- 4.4.10 Downloading Firmware from a Package Server
- 4.4.11 Activating New Firmware
- 4.4.12 Subaudible Signaling
- 4.4.13 SNMP Network Management
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- Appendix A – Interface Pin Allocations
- Appendix B– Installing the Firmware Package
- Glossary
- Tait General Software License Agreement
TB7300 Installation and Operation Manual Description 11
© Tait International Limited November 2019
1.2 Frequency Bands and Sub-bands
Much of the circuitry in the base station is common to all frequency bands,
and is therefore covered by a single description in this manual. In some
cases the descriptions refer to specific bands or sub-bands, and these are
identified with the letters listed in the following table.
Warning B3 and H5 bands are compliant with P25/AS-IP operation.
H3 band is not compliant with P25/AS-IP operation.
Frequency
Identification
Frequency Band and Sub-band 40W 50W
B band B3 = 148MHz to 174MHz x
✓
H band H3 = 470MHz to 520MHz
H5 = 400MHz to 470MHz
✓
✓
x
x