Installation and Operation Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Connecting to the Base Station
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Single or channel group base stations
- 4.4.6 Marshaling or transmit delay
- 4.4.7 Configuring Receive-Only Base Stations
- 4.4.8 Setting Up Custom Alarms
- 4.4.9 Uploading Firmware from the Base Station
- 4.4.10 Downloading Firmware from a Package Server
- 4.4.11 Activating New Firmware
- 4.4.12 Subaudible Signaling
- 4.4.13 SNMP Network Management
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- Appendix A – Interface Pin Allocations
- Appendix B– Installing the Firmware Package
- Glossary
- Tait General Software License Agreement
24 General Safety and Regulatory Information TB7300 Installation and Operation Manual
© Tait International Limited November 2019
2.3 Environmental Conditions
2.3.1 Operating Temperature Range
The operating temperature range of the equipment is –30°C to +60°C
(–22°F to +140°F) ambient temperature. Ambient temperature is defined
as the temperature of the air at the intake to the cooling fans.
2.3.2 Humidity
The humidity should not exceed 95% relative humidity through the
specified operating temperature range.
2.3.3 Dust and Dirt
For uncontrolled environments, the level of airborne particulates must not
exceed 100µg/m
3
.
2.4 Regulatory Information
2.4.1 Distress Frequencies
The 406 to 406.1MHz frequency range is reserved worldwide for use by
Distress Beacons. DO NOT program transmitters to operate in this
frequency range.
2.4.2 Compliance Standards
This equipment has been tested and approved to various national and
international standards. Refer to the latest issue of the Specifications
Manual for a complete list of these standards (MBD-00002-11).
2.4.3 Unauthorized Modifications
Any modifications you make to this equipment not authorized by Tait may
invalidate your compliance authority’s approval to operate the equipment.
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.