Installation and Operation Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Connecting to the Base Station
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Single or channel group base stations
- 4.4.6 Marshaling or transmit delay
- 4.4.7 Configuring Receive-Only Base Stations
- 4.4.8 Setting Up Custom Alarms
- 4.4.9 Uploading Firmware from the Base Station
- 4.4.10 Downloading Firmware from a Package Server
- 4.4.11 Activating New Firmware
- 4.4.12 Subaudible Signaling
- 4.4.13 SNMP Network Management
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- Appendix A – Interface Pin Allocations
- Appendix B– Installing the Firmware Package
- Glossary
- Tait General Software License Agreement
26 Operation TB7300 Installation and Operation Manual
© Tait International Limited November 2019
3 Operation
3.1 Front Panel LEDs
The indicator LEDs on the front panel are shown in Figure 3.1 below.
Power LED The green power LED is lit when power is supplied to the base station.
Alarm LED The red alarm LED flashes when an alarm has been generated by any of the
base station modules. It will continue to flash until the alarm is canceled or
the fault is fixed. Only alarms enabled using the web interface cause this
LED to flash.
Receive LED The amber receive LED indicates whether the base station is receiving a
valid RF signal on one or both logical channels.
Transmit LED The amber transmit LED is lit while the transmitter is transmitting.
Figure 3.1 LEDs on the front panel
b
power LED
d
receive LED
c
alarm LED
e
transmit LED
b
c
d
e
d
e
LED Description
Flashing One or more faults are present.
On (steady) A base station is in Offline mode, and no faults are present.
Off A base station is in Online mode, and no faults are present.
f
LED Description
On (steady) A base station is receiving a valid RF signal.
Off A base station is not receiving a valid RF signal.
g