Installation and Operation Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Connecting to the Base Station
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Single or channel group base stations
- 4.4.6 Marshaling or transmit delay
- 4.4.7 Configuring Receive-Only Base Stations
- 4.4.8 Setting Up Custom Alarms
- 4.4.9 Uploading Firmware from the Base Station
- 4.4.10 Downloading Firmware from a Package Server
- 4.4.11 Activating New Firmware
- 4.4.12 Subaudible Signaling
- 4.4.13 SNMP Network Management
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- Appendix A – Interface Pin Allocations
- Appendix B– Installing the Firmware Package
- Glossary
- Tait General Software License Agreement
TB7300 Installation and Operation Manual Connecting to the Base Station 39
© Tait International Limited November 2019
4.4.4 Working with Configuration Files
Channels To see all channels associated with both P25/AS-IP and DMR/MPT, go to
Configure > Base Station > Channels.
To make them easily recognizable, the licenses within this table are
prefixed with their specific software application (P25/AS-IP or DMR/
MPT).
If you attempt to go online with a channel that is invalid for the software
application you are currently using, an alarm will activate (Monitor >
Alarms). The alarm will warn you that the channel you are attempting
to use will not function.