Installation and Operation Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Connecting to the Base Station
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Single or channel group base stations
- 4.4.6 Marshaling or transmit delay
- 4.4.7 Configuring Receive-Only Base Stations
- 4.4.8 Setting Up Custom Alarms
- 4.4.9 Uploading Firmware from the Base Station
- 4.4.10 Downloading Firmware from a Package Server
- 4.4.11 Activating New Firmware
- 4.4.12 Subaudible Signaling
- 4.4.13 SNMP Network Management
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- Appendix A – Interface Pin Allocations
- Appendix B– Installing the Firmware Package
- Glossary
- Tait General Software License Agreement
40 Connecting to the Base Station TB7300 Installation and Operation Manual
© Tait International Limited November 2019
Managing
Configuration Files
Transferring Files
Specific software application configurations can be transferred between
base stations without overwriting identity information.
Configuration
It is important to note that configuration items such as the ‘Network Access
Code (NAC)’, (air-interface specific to the P25 channel) may not be visible
on the web user interface when running its software application equivalent.
However, its configuration is still preserved in the database.
Channels specific to analog, P25, DMR or MPT operation may not be
usable by their equivalent application, but they remain in the channel
table and can be edited if required.
At any time, you can save the current configuration settings as a file
(Tools > Files > Configuration > Backup configuration). This is stored in
the base station, but we recommend that you download it and store it on
your computer as an off-site backup. The base station identity and network
identity are not saved as part of the configuration file.
The following parameters are not restored on a base station when a
configuration is restored:
■ Keypad enabled
■ Trunking capability
■ Trunking control channel priority
■ Host name
■ Default channel
■ Operating mode
■ Front panel text lines 1 through 4
■ IP address
■ Subnet mask
■ Gateway address
■ Link speed
■ SSH enable
You may want to develop a master configuration and upload it to all base
stations in the network. The master configuration can contain all the
different channel configurations and can be common to all base stations.
The base station identity selects the default channel.
Base stations are shipped with a set of factory default configurations
featuring examples of channel setups for analog FM, P25, DMR and
MPT. These configurations provide a safe set of values.