Installation and Operation Manual
Table Of Contents
- Installation and Operation Manual
- Contents
- Preface
- 1 Description
- 2 General Safety and Regulatory Information
- 3 Operation
- 4 Connecting to the Base Station
- 4.1 PC Recommendations
- 4.2 Connecting Your PC to the Base Station
- 4.3 Working with the Web Interface
- 4.4 Basic Tasks
- 4.4.1 User Settings
- 4.4.2 Taking the Base Station Offline
- 4.4.3 Troubleshooting Alarms
- 4.4.4 Working with Configuration Files
- 4.4.5 Single or channel group base stations
- 4.4.6 Marshaling or transmit delay
- 4.4.7 Configuring Receive-Only Base Stations
- 4.4.8 Setting Up Custom Alarms
- 4.4.9 Uploading Firmware from the Base Station
- 4.4.10 Downloading Firmware from a Package Server
- 4.4.11 Activating New Firmware
- 4.4.12 Subaudible Signaling
- 4.4.13 SNMP Network Management
- 5 Installation
- 6 Maintenance
- 7 Troubleshooting
- Appendix A – Interface Pin Allocations
- Appendix B– Installing the Firmware Package
- Glossary
- Tait General Software License Agreement
TB7300 Installation and Operation Manual Installation 49
© Tait International Limited November 2019
5.2 Unpacking the Equipment
Unpacking the
Base Station
The base station is packed in a strong corrugated cardboard carton with top
and bottom cushions.
1. Cut the tape securing the flaps at the top of the carton and fold them
flat against the sides.
2. Rotate the carton carefully onto its side and then onto its top,
ensuring that none of the flaps are trapped underneath.
3. Slide the carton upwards over the cushions and lift it away. Remove
the cushion from the bottom of the base station.
4. Lift the base station clear of the remaining cushion.
Disposal of
Packaging
If you do not need to keep the packaging, we recommend that you recycle
it according to local recycling methods. The cushions are CFC- and HCFC-
free and may be burnt in a suitable waste-to-energy combustion facility, or
compacted in landfill.