Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
SCADA Gateway Installation and Configuration Manual Installation 15
© Tait Limited May 2017
2. Switch to root user by entering
1
:
su
k1w1
3. Stop the volume management by entering:
/etc/init.d/volmgt stop
4. Move out of the CDROM directory and unmount the DVD:
a. If the DVD ROM directory is /cdrom:
cd / && umount /cdrom
b. If the DVD ROM directory is /cdrom/cdrom0:
cd / && umount /cdrom/cdrom0
5. Start the volume management by entering:
/etc/init.d/volmgt start
6. Eject the CD either by pressing the eject button on the DVD drive,
or by using the following command:
eject cdrom
2.3 Installing the License Files
A SCADA gateway must have a valid license file installed before it can
operate.
License files can only be generated by Tait and each SCADA gateway must
have its own unique license. If the SCADA gateway has been set up by Tait
then an appropriate license file will have been installed. If not, then the
following procedures should be followed to obtain a valid license file.
2.3.1 Obtaining the Host ID for Requesting the License File
To obtain the host ID:
1. Log on to the SCADA gateway. The host ID can be found in
Settings
> Local Parameters > Identity > Host ID.
2. Once you have provided the host ID and required features to
Technical Support at Tait, you will be provided with a license file
called
TN9300-3_<hostid>_xxxx.lic. Rename and save the file
as
license.dat before uploading the license to the SCADA
gateway.
1. See Section 4.5 Changing the ‘root’ and ‘taitnet’ Passwords for instruc-
tions on changing the root password.