Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
16 Installation SCADA Gateway Installation and Configuration Manual
© Tait Limited May 2017
2.3.2 Uploading the license
1. To install the license file on the SCADA gateway, go to the SCADA
gateway web browser and select Settings > Local Parameters then
click Edit.
2. At the License file field, click Upload > Choose file to select a
license file, then click Open.
3. Once the license file has uploaded, the SCADA gateway will check
if the license is valid.
2.4 Recovering the DMR Node
2.4.1 CentOS
In the event issues with the operation of the DMR node are
observed during installation, DO NOT uninstall the SCADA gate-
way, as this attempts to remove the taitnet user account from which
the DMR node is run.
To disable the SCADA gateway service, execute the following commands
as root user:
# service scadagw stop
# rm -f /etc/rc0.d/K50scadagw
# rm -f /etc/rc2.d/K50scadagw
# rm -f /etc/rc3.d/S99scadagw
# rm -f /etc/init.d/scadagw
2.4.2 Solaris
In the event issues with the operation of the DMR node are observed during
installation, it is essential that the node is taken back to a known working
state to ensure minimum disruption to network service. The following steps
detail how to achieve this.
1. If you have not already done so, insert the USB flash drive. (See
Section 2.2 Installing the SCADA Gateway on the DMR Node Con-
troller.)
a. Once you are in the right sub-directory (cdrom or cdrom0), enter
the following command:
ls
b. If you can see the file installvm, enter the following command: