Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
22 Configuration SCADA Gateway Installation and Configuration Manual
© Tait Limited May 2017
8. Add the DMR addresses of the TD9300 data terminals and the
SCADA master DIP connection to the fleet created in
Step 6.
a. Select Subscribers > Fleets and then click the fleet that the data
terminals will belong to.
b. Click the Units tab and then click Add. The Add Unit page
appears.
c. Enter the terminal number. This must be a number that lies within
the number range assigned to the fleet. If you add multiple termi
-
nals, they will be numbered starting from this number.
d. Optionally add a comment to give more information about the
terminal.
e. Optionally enter the terminal’s authentication key. This is the fac-
tory-programmed authentication key that is checked by the node
to ensure that a terminal registering on the network is genuine.
(Use the terminal’s serial number as the authentication key.)
f. If you want to add more than one terminal, enter the number of
terminals into the Number of units to add box.
g. Select a profile, and service area from the drop-down lists.
h. Click Save.
9. Ensure the node is licensed for sufficient DIP calls (TNAS303).
10. Ensure the node is licensed for sufficient data calls (TNAS305).
11. In the event issues are encountered subsequent to installation, refer
to
Section 2.4 Recovering the DMR Node.
3.2 Logging on to the SCADA Gateway WebUI
For SCADA gateways running firmware versions up to 1.03, on your PC
web browser enter the following:
https://<SCADAGateway-ip-address>
For SCADA gateways running firmware versions 1.04 and later, on your
PC web browser enter the following:
https://<SCADAGateway-ip-address>:17443
In High Availability configurations, access to the WebUI is only
allowed to the actual IP address for the SCADA gateway as specified in
the Network Connection tab. Accessing the WebUI using the active
SCADA gateway IP address will not work.
Supported
Browsers
WebUI access has been tested on the following browsers, and are therefore
recommended for use:
■ Mozilla Firefox
■ Google Chrome