Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
SCADA Gateway Installation and Configuration Manual Configuration 27
© Tait Limited May 2017
c. The gateway needs to be rebooted to apply the changes. To reboot
the gateway, connect to it by SSH and login as root (see
Section 4.1 and Section 4.2). Issue the command reboot.
If the SCADA gateway is running on a CentOS DMR node this will also
reboot the DMR node.
3.4.3 Synchronizing the Secondary SCADA Gateway Database
1. Select Settings > Local Parameters and click Edit.
2. Set the mode to Online.
3. The State displayed in the status bar should be Standby.
4. Select Network > Gateways to confirm that the Gateways list
contains the Active SCADA gateway and that the Connection
Uptime is incrementing. The Database Synchronized column is
likely to show No for the Active gateway.
5. Select Settings > Local Parameters and click Edit.
6. Set the mode to Program.
7. Wait until the State displayed in the status bar shows Offline.
8. Select Settings > Local Parameters and click Edit.
9. Set the mode to Online.
10. The State displayed in the status bar should be Standby.
11. Select Network > Gateways to confirm that the Gateways list
contains the Active SCADA gateway and that the Connection
Uptime is incrementing. The Database Synchronized column should
now show Yes for the Active gateway.