Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
32 Administrating the SCADA Gateway SCADA Gateway Installation and Configuration Manual
© Tait Limited May 2017
2. Click ‘Certificate error’. The following screen is displayed:
3. Click ‘View certificates’. The Certificate popup with General tab is
displayed:
4. Click ‘Install Certificate...’ and then follow the Certificate Import
Wizard to install the certificate. Proceed to the end without changing
the default values. When the Security Warning window appears,
click Yes.
Windows 7 and
Internet Explorer
When using Windows 7, step 4 of the procedure for Internet Explorer will
not remove the Certificate error. Replace step 4 with the following:
1. Click ‘Install Certificate’. In the Certificate Import Wizard click
Next.
2. Select ‘Place all certificates in the following store’ and click Browse.
3. Select ‘Trusted Root Certification Authorities’ and click OK.