Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
42 Uploading SCADA Gateway Firmware SCADA Gateway Installation and Configuration Manual
© Tait Limited May 2017
5.3 Reverting to an Earlier Firmware Version
The procedure in "Upgrading the SCADA Gateway to a New Firmware
Version" can also be used to revert to a previous version of the firmware.
When the SCADA gateway firmware is upgraded, the old firmware is not
overwritten. Simply select the firmware version to which you wish to
revert.
IMPORTANT - On a CentOS DMR co-hosted installation do not
attempt to downgrade from 01.04.02 to any earlier version.