Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
46 Transferring an ISO Image to a USB Flash Drive SCADA Gateway Installation and Configuration Manual
© Tait Limited May 2017
3. Run the Rufus program.
4. Check that the Device in the first drop down list is the same as the
USB flash drive.
5. Click on the CD icon next to the drop down list containing
‘FreeDOS’. This will open a dialog box to enable the selection of the
ISO file to be written to the USB flash drive.
6. Select the ISO file and click Open, which takes you back to Rufus.