Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
SCADA Gateway Installation and Configuration Manual Transferring an ISO Image to a USB Flash Drive 47
© Tait Limited May 2017
7. When ready to start the writing process, click Start.
8. A dialog box will appear to confirm that a write operation is to be
carried out. At this point double check that the correct device is
being written to and then click OK.
Depending on how large the ISO file is and the write speed of the
USB flash drive, it could take from less than a minute to half an hour
or more to complete the write process.