Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
SCADA Gateway Installation and Configuration Manual Transferring an ISO Image to a USB Flash Drive 49
© Tait Limited May 2017
4. Check that the drive letter in the Device drop down list is the same
as the USB flash drive. If you get this wrong, you could erase the
wrong disk.
5. Click on the folder icon for the Image file.
6. Change the file filter from Disk Images (*.img *.IMG) to *.*
7. Select the desired iso file and click Open.
8. When ready to proceed, click Write.