Installation Instructions
Table Of Contents
- Installation and Configuration Manual
- Tait Communications Corporate Head Office
- Contents
- Preface
- 1 Introduction
- 2 Installation
- 3 Configuration
- 4 Administrating the SCADA Gateway
- 4.1 Logging on to the SCADA Gateway
- 4.2 Logging on to the SCADA Gateway as ‘root’
- 4.3 Self-Signed SSL Certificates
- 4.4 Using the Certificate from a Certification Authority (CA)
- 4.5 Changing the ‘root’ and ‘taitnet’ Passwords
- 4.6 Stopping/Starting the SCADA Gateway Software
- 4.7 Changing to a Local Time Zone
- 4.8 SCADA Gateway Resource File
- 5 Uploading SCADA Gateway Firmware
- 6 Backing up/Restoring Configuration Files
- Appendix 1: Transferring an ISO Image to a USB Flash Drive
- Appendix 2: Adding an Alternate Interface in CentOS
50 Transferring an ISO Image to a USB Flash Drive SCADA Gateway Installation and Configuration Manual
© Tait Limited May 2017
9. A Confirm overwrite dialog will appear which gives you a last
chance to abort the process. Click Yes to continue.
10. The writing to the USB flash drive will begin and, depending on the
quality/speed of the USB flash drive, this could take some time.
11. When the write has completed, a completion dialog will appear.
Click OK.
12. Close the Win32DiskImager program.
13. Eject the USB flash drive by clicking the Safely Remove
Hardware and Remove Media
icon in the notification area, then
clicking on the USB flash drive device.
14. Remove the USB flash drive from the PC.