User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Getting started
- 3 Basic operation
- 4 Using the address book
- 5 Operating in conventional mode
- 6 Operating in trunked mode
- 7 Dialing calls in trunked mode
- 8 Location services
- 9 Loneworker monitoring
- 10 Encryption
- 11 Customizing radio settings
- 12 Troubleshooting
- Simplified Declaration of Conformity
- Tait Software Licence Agreement
22 Getting started
About your DMR digital radio
Your DMR digital radio can be programmed for DMR
conventional or DMR trunked operation. Analog
conventional and MPT operation is also available.
DMR and MPT trunking operation is controlled
by a software license (SFE) and may not be
available with your radio.
In DMR and MPT trunking operation, dual-mode
networks are able to receive both digital and analog
calls.
You may notice differences between digital and
analog calls in terms of:
■ static noise in low signal areas, and
■ radio coverage in marginal reception areas.
Lack of static noise
On digital networks there is no static noise, even in
low signal areas. This lack of static is because your
digital radio removes the ‘noise’ from the call, so that
you hear only clear voice.
Coverage
With digital networks, a call remains clear and then
drops off quickly at the border of a coverage area. The
reason for this is that a digital call is either received or
it isn't. With analog networks, the background noise in
a call gets progressively worse when you are in fringe
areas or even slightly outside normal coverage areas.