User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Getting started
- 3 Basic operation
- 4 Using the address book
- 5 Operating in conventional mode
- 6 Operating in trunked mode
- 7 Dialing calls in trunked mode
- 8 Location services
- 9 Loneworker monitoring
- 10 Encryption
- 11 Customizing radio settings
- 12 Troubleshooting
- Simplified Declaration of Conformity
- Tait Software Licence Agreement
Operating in conventional mode 79
The green LED stops flashing, and the monitor
icon disappears from the display.
Using the function key programmed for reset
monitor/call cleardown to end active calls
The function key programmed for reset monitor may
be programmed so that a short key press ends your
current call, and a long key press ends all active calls
in your group.
Using monitor and squelch
override (on analog channels)
The monitor function allows you to override some or
all of the radio’s mutes, and hear if there is any traffic
on a channel before you make a call.
The squelch override function lets the radio user
override the squelch (carrier) mute and hear all noise
on a channel, including weak signals that are below
the programmed squelch threshold.
Your radio may be programmed to activate
monitor whenever the microphone is off the
microphone clip.
To turn monitor on and off:
1 Press Menu and select Radio settings >
Functions > Monitor.
(Depending on how your radio is programmed, you
may be able to press a function key to toggle
monitor on and off.)
2 Scroll to On (or Off) and press Select.
While monitor is on, the green LED flashes slowly
and the monitor icon appears in the display.
Your radio may be programmed so that monitor
turns off automatically after a short time.