User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Using the address book
- 6 Operating in conventional mode
- 7 Operating in trunked mode
- 8 Dialing calls in trunked mode
- 9 Location services
- 10 Loneworker monitoring
- 11 Encryption
- 12 Customizing radio settings
- 13 Charging and caring for batteries
- 14 Troubleshooting
- Simplified Declaration of Conformity
- Tait Software Licence Agreement
166 Charging and caring for batteries
If a radio was turned on while being charged, the
battery indicator may not be accurate when the radio
is initially removed from the charger. After a few
seconds, the battery indicator is updated to display
the amount of charge available in the battery
.
Low battery warning
Notice Do not allow a radio battery to fully discharge
every time you use it, or you will shorten the service
life of the battery.
When the battery is low, your radio warns you in the
following ways:
■ The battery symbol on the radio display looks
empty.
■ The status LED on the radio slowly flashes red.
■ A high-pitched beep sounds.
You should recharge or replace the battery as soon
as possible.
When the battery is completely empty, the message
Battery is flat appears on the display. The radio emits
a long, low-pitched beep and then stops working.
Turn off the radio.