User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu maps
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Basic operation
- 5 Using the address book
- 6 Operating in conventional mode
- 7 Operating in trunked mode
- 8 Dialing calls in trunked mode
- 9 Location services
- 10 Loneworker monitoring
- 11 Encryption
- 12 Customizing radio settings
- 13 Charging and caring for batteries
- 14 Troubleshooting
- Simplified Declaration of Conformity
- Tait Software Licence Agreement
Operating in conventional mode 99
The LED glows red and a message appears in the
display.
If the radio has been successfully returned to
operation, an acknowledgement message is
displayed.
The uninhibited radio will briefly display Radio
revived.
If an acknowledgement is not received from the
recipient’s radio, you will have the option of either
canceling or resending the request.
Resending calls automatically
On an analog channel, your radio may have been
programmed to resend individual and group calls
when transmission is refused because the channel is
busy.
There are two automatic callback features:
■ deferred calling
■ no acknowledgement retries
Deferred calling
When you attempt to make a call on a channel that is
busy, the radio can store and send the call once the
channel is free. The radio gives a low-pitched beep if
the channel is busy, and then waits until the channel
is free to retry the call.
Sending
uninhibit to
Car 2
Cancel
Ack received
OK