User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu map
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Operation
- Turning the radio on and off
- Adjusting the speaker volume
- Connecting to a Bluetooth® device (TP3350 only)
- Answering a Call Alert
- Selecting a zone
- Selecting a channel
- Changing a Channel
- Making a group call
- Making a private call
- Turning scanning on and off
- Making a call alert
- Sending a quick text message
- Sending an emergency alarm
- Turning location information on and off (TP3350 only)
- 5 Charging and caring for batteries
- About the chargers
- Before using the charger
- Charging temperatures
- Leaving the battery on charge
- Receiving calls while charging
- Low battery warning
- Charging a battery for the first time
- Charging a battery
- LED behavior
- Removing the battery from the charger
- Maintaining battery life and performance
- Storing batteries
- Disposing of batteries
- 6 Troubleshooting
- Tait Software Licence Agreement
- Simplified Declaration of Conformity
26 Before using your radio
Attaching the battery
1 Rotate the power/volume control switch
counterclockwise to turn off the radio.
If the battery has been attached while the radio
is turned on, turn the radio off and then on again
before use.
2 Insert the top of the
battery into the recess at
the back of the chassis.
3 Lightly press the bottom
of the battery towards
the radio until the battery
catch clicks.
4 Make sure that the
battery is firmly in
position.
Removing the battery
The battery is secured to the radio by a battery catch
in the radio’s rear panel.
To remove the battery from the radio, so that the
battery can be charged or replaced:
1 Rotate the power/volume control switch
counterclockwise to turn off the radio.
If the battery has been removed while the radio
is turned on, turn the radio off and then on again
before use.
2 Push the PRESS button at the bottom of the radio
to release the battery catch, and pull the battery
away from the radio.