User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu map
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Operation
- Turning the radio on and off
- Adjusting the speaker volume
- Connecting to a Bluetooth® device (TP3350 only)
- Answering a Call Alert
- Selecting a zone
- Selecting a channel
- Changing a Channel
- Making a group call
- Making a private call
- Turning scanning on and off
- Making a call alert
- Sending a quick text message
- Sending an emergency alarm
- Turning location information on and off (TP3350 only)
- 5 Charging and caring for batteries
- About the chargers
- Before using the charger
- Charging temperatures
- Leaving the battery on charge
- Receiving calls while charging
- Low battery warning
- Charging a battery for the first time
- Charging a battery
- LED behavior
- Removing the battery from the charger
- Maintaining battery life and performance
- Storing batteries
- Disposing of batteries
- 6 Troubleshooting
- Tait Software Licence Agreement
- Simplified Declaration of Conformity
Before using your radio 27
Attaching the antenna
Before using the radio, screw the antenna clockwise
into the antenna connector. The antenna should be
screwed sufficiently tight so that it doesn’t unscrew
easily. This is important as it creates a seal.
Removing the antenna
Warning Do not change the antenna in a hazardous
location. An explosion could cause serious injury or
death.
Use a firm grip and turn the antenna counterclockwise
half a turn. Use a lighter grip to fully unscrew the
antenna, and carefully remove it.
Replacing the belt clip
1 To remove the belt clip, use a
Pozidrive screwdriver to undo
the two belt clip screws.
2 To attach the belt clip, use a
Pozidrive screwdriver to fasten
the two belt clip screws.