User's Guide
Table Of Contents
- User’s Guide
- Contents
- For your safety
- Menu map
- 1 About this guide
- 2 Before using your radio
- 3 Getting started
- 4 Operation
- Turning the radio on and off
- Adjusting the speaker volume
- Connecting to a Bluetooth® device (TP3350 only)
- Answering a Call Alert
- Selecting a zone
- Selecting a channel
- Changing a Channel
- Making a group call
- Making a private call
- Turning scanning on and off
- Making a call alert
- Sending a quick text message
- Sending an emergency alarm
- Turning location information on and off (TP3350 only)
- 5 Charging and caring for batteries
- About the chargers
- Before using the charger
- Charging temperatures
- Leaving the battery on charge
- Receiving calls while charging
- Low battery warning
- Charging a battery for the first time
- Charging a battery
- LED behavior
- Removing the battery from the charger
- Maintaining battery life and performance
- Storing batteries
- Disposing of batteries
- 6 Troubleshooting
- Tait Software Licence Agreement
- Simplified Declaration of Conformity
Charging and caring for batteries 57
Charging a battery for the first
time
Fully charge a battery before using it for the first time.
The red LED stays lit while the battery charges.
Charging a battery
Notice For best charging performance, switch off the
radio before placing it in the charger.
1 Desktop charger: Connect the charger to the
correct Tait power adaptor.
6-way charger: Power on the charger.
Initially, all three LEDs are lit for 2 seconds.
2 Place just a battery in the charger, or a radio with
a battery attached (desktop charger or 6-way
charger only). There is no need to remove a belt
clip, antenna, or any accessory that is attached to
the accessory connector.
The red LED lights up, and stays lit while the
battery charges.
When charging is complete, the green LED stays
lit.