User's Manual Part 6
- 3
- (&$%:3
To read the radio software version of a T2000 Series II radio, hold in the PTT switch
when turning on the radio. The version number will then be displayed briefly on the
radio’s front panel, using either the LEDs, the 7 segment display panel or a combination
of both.
Where LEDs are used, they indicate Binary Coded Decimals (BCDs), with the most sig-
nificant bit to the left.
The examples below show how each radio displays “Version 3.02”.
:" This is not necessarily a valid radio software version.
• The major version number is indicated as a BCD by the
Busy and Tx LEDs. (“3” in the example on the right.)
• The two digit minor version number is indicated as
BCD digits by the two lower rows of LEDs. (“0” on the
middle row and “2” on the lower row in the example.)
<*
• The major version number will be indicated as a binary
coded decimal (BCD) by the Busy and Tx LEDs.
• The minor version number is shown in the two digit
display.
• The major version number is indicated as a binary
coded decimal (BCD) by the top row LEDs.
• The two digit minor version number is indicated as
BCD digits by the two lower rows of LEDs.
• The full version number is shown in the display.
AA
• The full version number is shown in the display.
1
2
3
4
BUSY
TX
BUSY
TX
C1
C2 C3
C4
Fn
SVC WAIT GO
TX
BUSY
TX
WAIT