User's Manual Part 5

 &'() 
  
4 Refer to Figure 8.4.1.
Remove the existing internal speaker link and insert the three speaker wire recep-
tacles into the appropriate power connector holes, as shown.
If the internal speaker is not required, cut the internal speaker ground link.
 '  ( 
5 Plug the speaker into the socket provided on the speaker wire, neatly loop any
excess wire and secure with a cable tie.
Peel the protective plastic off the “Tait” label on the front of the speaker.
Internal speaker link
(T2010, T1015 & T2030:
cut to disable)
Ignition
External
Power supply:
13.8V
Ground
External speaker:
Ground
Liv
e
{
Not normally
fitted