User's Manual Part 5

+ -.) 
  
+ !)6(
The T2000-34 kit contains the following components:
+ .
&

Refer to Figure 8.7.1 and Section 7.10, “T2010 & T2015 HC05 Logic PCB”.
1 Remove the top cover of the radio by unscrewing the four cover screws, unscrew
the logic PCB and fold-out.
2 Unplug the connecting looms, if required.
3 Place the Selcall module flat on the logic PCB, as shown in Figure 8.7.1, with the
component side facing upwards.
Solder the leads on the bottom side of the PCB and trim as necessary.
4 Fit the supplied 5MHz crystal flat on the PCB in location ‘#X502’ as follows:
Peel the protective backing off the self-adhesive foam tape on the underside of the
crystal.
Insert the crystal leads into the holes provided and press the crystal down onto
the PCB.
Solder the leads on the underside of the PCB and trim as necessary.
5 Reconnect any looms that were unplugged in step 2.
Refit the logic PCB to the radio and secure with the three retaining screws.
Refit the top cover and secure with the four retaining screws.
Quantity Description
1 T2000-34 Selcall module
1 5MHz crystal with insulator