User's Manual Part 5

 123) 
  
 !)6(
The T2000-50 kit contains the following components:
 .
&

1 Refer to Figure 8.11.1.
Remove the top cover of the radio by unscrewing the four cover screws, unclip the
D-range blanking plate in the rear of the T2000 radio, unscrew the logic PCB and
fold-out.
Position the T2000-50 PCB as shown, and connect the Micromatch connectors P13
and P14 to S13 and S14 on the T2000 logic PCB.
    0% & *
2 T2010 & T2015: Remove R513 (0Ω resistor) on the logic PCB.
Quantity Description
1 T2000-50 PCB assembly
1 directional microphone (with optional sunvisor clip or tie clip)
1 footswitch
1
9 way D-range assembly with 2 in-line connectors & microphone socket
attached
1 shroud (alternative shroud - not required for T2000 Series II radios)
1 2 way in-line connector
3 M3x8 pan Pozi Taptite screws
2 4-40x¼ pan Pozi Taptite screws (black)