User's Manual Part 5
123)
; ;4
56)6(
T2000-50 set-up should only be necessary after major repair.
• AF signal generator
• modulation analyser
• high impedance voltmeter (e.g. VTVM)
• oscilloscope
• power supply (+13.8V)
• RF power meter or load
• 30dB RF attenuator
The following diagram shows a typical test set-up.
12 $3
1 Set up the equipment as shown in Figure 8.11.2, and set the audio generator to
1kHz at a level of 0.8mV.
Switch on the T2000 and check the increase in current with the T2000-50 fitted is
less than 30mA.